Strong support from distributors of pengukur aliran airs with high production standards.
To pursue the quality of water, use the water meter itself. Providing a wide range of basic functions and convenience for commercial settlement, water meters usually enjoy it.
Although water resources utilize water flow, some applications may choose an undesirable method.
It is recommended not to trade any units using water meters. It is important to ensure that the custodians receive training and have a clear understanding before arranging a solution.
The control pointer is generally installed with 6-bit Nixie tube, which is composed of 8 crystal keys and must be covered by LCD accumulatively. Otherwise, modifications should be made. Additionally, install a flow meter and pressure transmitter at this location. According to the general data, it shall be ensured that there are five kinds of solid particles before the pressure and temperature measurement. The solid particles represent accumulated water, and the composite particle parts are air. For example, Pitot tube and sponge purging are used for measurement on the concrete.
Set the alarm value to the east and set the alarm position according to points 1, 2, or 3 to ensure that the measured value enters the front limit switch.
Set the alarm setting value to the east and press the 21 key left or left key to complete the alarm and corresponding actions.
Set the alarm output to the right, or toggle to enter the set value setting and Factory reset. Place the alarm output at the desired setting position, press the start button, and select the sequence segment for alarm and shutdown. After setting the timing, press the start button,
Set the alarm output to the left, or toggle to enter the set point to complete the setting. Place the alarm output at the desired set point.
Delay setting: Press the alarm parameters to set the difference in sequence, and press the start button to exit the setting. After setting, press the start button to exit the setting.
After setting the alarm, press the start button to exit the setting and transmit the output: convert the pressure sensor and pressure gauge conversion switch to proportional output, and press the reset button.
After setting, press the start button, the alarm output is successful, and adjust the return difference to the alarm output. By setting the output type of the expansion controller, users can increase the output mode according to specific circumstances.
When the pressure rises, the displayed content on the display screen after the transmission output is greater than the content displayed on the upper and lower pressure limits. If it is the content displayed on the test pressure display, we will conduct a detailed analysis for you.
Users must connect the transmitter and pressure transmitter to the system junction box before wiring, so as not to affect the power operation of the system