Trasmettitore di livello radar senza contatto a 80 GHz (nuovo modello: SYRD)
Typical application
● Measure the liquid level of reaction still.
● Measure the liquid level of vessel which has a large amount of steam.
● Measure the level of liquid which have foam on surface
● Measure the liquid level of Crystalline substance.
● Measure the liquid level of Ultra high temperature.
● Measure the liquid level of Ultra high pressure.
● Measure the level of Sanitary liquid.
Descrizione del prodotto
Principio
The 80G radar level meter adopts technology of frequency modulated (FM) continuous wave (FMCW). The antenna emits high-frequency FM radar signals, and the frequency of the radar signal increases linearly. The FM radar signals are received by the same antenna after being reflected from the measured medium. At the same time, the frequency difference between the transmitted signal and the received signal is in direct proportion to the measured distance. The frequency difference signal collected get through fast Fourier transform (FFT) to produce the reflection echo frequency spectrum, the distance to the target will be calculated base on the reflection echo frequency spectrum.
Caratteristica
● Millimeter wave radar, measuring accuracy up to ±1mm, measuring minimum blind area of 0.05m.
● Smaller antenna size, meet measurement for more working conditions.
● Smaller beam angle, more concentrated energy, stronger echo signal, has higher reliability compared with other type radar level meters at the same process conditions.
● With stronger penetrability, it also can be used for the working condition of adhesion and condensation.
● Larger dynamic signal range, measurement is more stable for medium of low dielectric constant.
● Multiple measurement modes, radar response time is less than 1S in fast measurement mode.
Advantage
● Transmitter housing IP 67
● Antenna with Fluoroplastic lens protection for anticorrosion condition
● Beam angle is very small
● Can customize special model for liquid level of temperature up to 1000℃
● Vapor and flying ash does not affect measurement
● Level measurement for boiling liquid
● Level measurement for corrosive liquid
Product Model and technical data
| Modello |
Dati tecnici |
| SYRD-80G01
|
Measured medium: Liquid ( Non-corrosiveness ) Measuring range: 0.05 ~ 30 mProcess connection: G 1.5 A / G1.5 NPT / Flange ( Size ≥ DN40 ) Process temperature: -40 ~ 80 ℃ Process pressure: -0.1 ~ 0.3 Mpa Antenna size: 32mm lens antenna Antenna material: PTFE Precisione: ± 3 mm Weather-proof: IP67 Center frequency: 123 GHz Beam Angle: 7° Power supply: 24VDC ( 2-wire ), 24VDC ( 4-wire ), 220VAC ( 4-wire ) Transmitter housing option: Aluminum / Stainless steel Segnale di uscita: 4 ~ 20mA (2-wire), HART protocol 4 ~ 20mA (4-wire), RS485 ( Modbus protocol ) |
| SYRD-80G02
|
Measured medium: Liquid ( Non-corrosiveness ) Measuring range: 0.1 ~ 100 m Process connection: Flange ( Size ≥ DN80 ) Process temperature: -40 ~ 110 ℃Process pressure: -0.1 ~ 1.6 Mpa Antenna size: 32mm lens antenna Antenna material: PTFE Precisione: ± 3 mm ( for range＜35 m ); ±5 mm ( for 35m≤range＜100 m ) Weather-proof: IP67 Center frequency: 80 GHz Beam Angle: 7° Power supply: 24VDC ( 2-wire ), 24VDC ( 4-wire ), 220VAC ( 4-wire ) Transmitter housing option: Aluminum / Stainless steel Segnale di uscita: 4 ~ 20mA (2-wire), HART protocol 4 ~ 20mA (4-wire), RS485 ( Modbus protocol ) |
| SYRD-80G03
|
Measured medium: Strong corrosive liquid with steam or froth on surface (froth height shall not more than 30cm ) Measuring range: 0.1 ~ 100 m Process connection: Flange ( Size ≥ DN50 ) Process temperature: -40 ~ 130 ℃ Process pressure: -0.1 ~ 2.5 Mpa Antenna size: Customize according to flanges size Antenna material: PTFE Precisione: ± 3 mm ( for range＜35 m ); ±5 mm ( for 35m≤range＜100 m ) Weather-proof: IP67 Center frequency: 80 GHz Beam Angle: 6° Power supply: 24VDC ( 2-wire ), 24VDC ( 4-wire ), 220VAC ( 4-wire ) Transmitter housing option: Aluminum / Stainless steel Segnale di uscita: 4 ~ 20mA (2-wire), HART protocol 4 ~ 20mA (4-wire), RS485 ( Modbus protocol ) |
| SYRD-80G04
|
Measured medium: High temperature strong corrosive liquid with steam or froth on surface (froth height shall not more than 30cm ) Measuring range: 0.1 ~ 35 m Process connection: Flange ( Size ≥ DN50 ) Process temperature: -40 ~ 200 ℃ Process pressure: – 0.1 ~ 1.0 Mpa Antenna size: 46mm lens antenna Antenna material: PTFE Precisione: ± 3 mm Weather-proof: IP67 Center frequency: 80 GHz Beam Angle: 6° Power supply: 24VDC ( 2-wire ), 24VDC ( 4-wire ), 220VAC ( 4-wire ) Transmitter housing option: Aluminum / Stainless steel Segnale di uscita: 4 ~ 20mA (2-wire), HART protocol 4 ~ 20mA (4-wire), RS485 ( Modbus protocol ) |
| SYRD-80G05
|
Measured medium: High temperature & High pressure strong corrosive liquid with steam or froth on surface (froth height shall not more than 30cm ) Measuring range: 0.1 ~ 35 m Process connection: Flange ( Size ≥ DN80 ) Process temperature: -40 ~ 200 ℃ Process pressure: – 0.1 ~ 2.5 Mpa Antenna size: Customize according to flanges size Antenna material: PTFE / ( Overall filling ) Precisione: ± 3 mm Weather-proof: IP67 Center frequency: 80 GHz Beam Angle: 3° Power supply: 24VDC ( 2-wire ), 24VDC ( 4-wire ), 220VAC ( 4-wire ) Transmitter housing option: Aluminum / Stainless steel Segnale di uscita: 4 ~ 20mA (2-wire), HART protocol 4 ~ 20mA (4-wire), RS485 ( Modbus protocol ) |
| SYRD-80G06
|
Measured medium: Solid, Storage containers, process containers or the places with heavy dust. Measuring range: 0.3 ~ 150 m Process connection: Flange ( Size ≥ DN100 ) Process temperature: -40 ~ 110 ℃ Process pressure: – 0.1 ~ 0.3 Mpa Antenna size: 74.7mm lens antenna + Flange of Universal Joint ( Optional: Purging device ) Antenna material: PTFE / ( Overall filling ) Precisione: ±5 mm Weather-proof: IP67 Center frequency: 80 GHz Beam Angle: 3° Power supply: 24VDC ( 2-wire ), 24VDC ( 4-wire ), 220VAC ( 4-wire ) Transmitter housing option: Aluminum / Stainless steel Segnale di uscita: 4 ~ 20mA (2-wire), HART protocol 4 ~ 20mA (4-wire), RS485 ( Modbus protocol ) |
Remark: If medium temperature reach to 1000℃, we will customize Ultra high temperature type.
Installation attentions:
1> Avoid installing the instrument in a central location or close to the edge of the container, otherwise it is likely to produce erroneous readings.
2> Example of avoiding false echo
3> Handling of stairs and grille tanks
4> Handling of wall hanging and grille tank
Prodotti correlati
-
Strumento di livelloIndicatore di livello magnetico montato in alto (nuovo modello: SY-UF)
Per saperne di più -
Strumento di livello
Trasmettitore di livello a distanza a ultrasuoni (nuovo modello: SYCW)
Per saperne di più -
Trasmettitore di livello con singola guarnizione remota
Trasmettitore di livello con singola guarnizione remota
Per saperne di più -
FAQ
Arisposta : Inviate la vostra domanda o richiesta al nostro indirizzo e-mail: sales@hginstrument.com, inoltreremo le domande all'ingegnere di riferimento.
Arisposta : Per favore comunicare con le vendite la procedura di restituzione prima di restituire il prodotto.
Arisposta : I tempi di consegna dipendono dalla quantità ordinata e dalle specifiche del prodotto. Se le specifiche del prodotto sono convenzionale (non speciale), I tempi di consegna sono di 5 o 7 giorni lavorativi per quantità d'ordine ≤ 10 pezzi; I tempi di consegna sono di 2 o 3 settimane lavorative per quantità d'ordine 15 ~ 30 pezzi.
Arisposta Per corriere, via mare o per via aerea
Arisposta : Sì, in genere la garanzia è di un anno.
Arisposta : Dal 2015 al 2021, il fatturato medio annuo è di 350 milioni di RMB (circa 54,7 milioni di USD).