Misuratore di livello a ultrasuoni Sonar non invasivo

Principio di funzionamento

Non-invasive sonar ultrasonic level meter adopts the principle of sonar echo measuring distance, overcome the influence of the tank wall on the transmission of ultrasonic signals, use advanced digital signal processing technology, it achieves non-contact, high-precision liquid level measurement for the closed tanks. This type liquid level meter can output 4-20mA analog current signal or output the measurement result to the upper computer through the RS485 interface to realize automatic control.

Product feature

• The sonar ultrasonic level probe is attached on external wall of container, no need to open holes on the container.
• Has self-calibration function, overcomes the problem that the accuracy of the traditional liquid level meter is reduced after long-term use.
• Be convenient for the infrared remote controller to operate, especially suitable for the situations that it is not suitable to open the instrument cover for debugging in dangerous area.
• Has self-diagnosis function, as well as hardware diagnosis function, which enhances the reliability and stability of the level meter.
• When the liquid level meter works abnormally, it can be restored to the normal state with one key operation on the infrared remote controller.
• The level meter can display the measured liquid level value, also can transmit the measure data to the control room through signal line.

Application condition

• Medium purity: the liquid shall not be filled with dense air bubbles; shall not suspend a large amount of solids, such as crystals, the bottom of the tank shall not has a large amount of sediment.
• Materiale del contenitore: acciaio al carbonio, acciaio inox, vari metalli duri, plastica rinforzata con fibre di vetro, resina epossidica, plastica dura, ceramica, vetro, gomma dura o altri materiali compositi.
• Forma del serbatoio applicabile: Serbatoio orizzontale, serbatoio sferico, serbatoio a trogolo, serbatoio verticale, ecc.
• Supporto applicabile:

C3, Mother liquid ammonia, liquid ammonia, acetone, propylene, diesel, nitrogen methyl, aniline, Butadiene, butane, Xylene, dimethyl ether, Aromatic hydrocarbons, Phenol water, hydrogen fluoride, Freon, Propylene oxide, ethylene oxide, methylamine, Toluene, methanol, Methyl tert-butyl ether, formaldehyde, Alcohol,  polyethylene, sulfuric acid, Chlorobenzene, methyl chloride, vinyl chloride, kerosene, concentrated sulfuric acid, UDMH, gasoline, light hydrocarbons, hydrofluoric acid, trifluoroethylene, tetrachloroethylene, banana water, Anhydrous hydrogen fluoride, nitric acid, bromine, hydrochloric acid, liquid ammonia, liquefied carbon dioxide, liquefied gas, liquefied petroleum gas, Liquefied hydrocarbons, liquid chlorine, ethanol, ether, ethane, ethylene, ethylene propylene, isobutane, isobutene, feedstock oil, n-butane, vegetable oil.

• Probe installation requirements

1). There are no obstructions such as coils directly above the probe.
2). The probe is higher than the sewage outlet.
3). The probe shall be far away from the liquid inlet at the bottom of the tank, also shall be far away from the location which is under face the liquid inlet at the top of the tank.
4). When the level probe is installed by magnetic/adhesive method, the diameter of the installation surface on the container’s external wall shall not be smaller than Φ100mm. The surface roughness should reach Ra 1.6, and the inclination shall be less than 3° (except the bypass pipe).

Technical parameter

Installation diagram

Caso di applicazione